Name: Laboratory Electric Distiller for Experiments
Brand: ULabs
Availability: InStock

Unpack the product, remove the transport inserts and rinse the boiling chamber and the receiving vessel with clean water
Place the appliance on a level heat-resistant surface near a socket, leaving free air circulation around the condenser unit
Run one full distillation cycle before the first use and pour the resulting water away - this removes production residues

Fill the boiling chamber with tap or pre-filtered water to the upper level mark, without exceeding it
Fit the condenser unit, place the receiving vessel under the outlet pipe and connect the product to the socket
Switch the appliance on; distillate appears at the outlet after the water boils, and the output reaches its rated value in about 10-15 minutes
After the cycle switch the appliance off, disconnect it from the socket, let it cool and drain the remaining water from the boiling chamber
Store the distilled water in a clean closed vessel of glass or food-grade polymer

Connect the product only to a power source with the voltage, frequency and rated parameters stated on the product rating plate
Keep close supervision when the product is used by students or works near them, and never leave it switched on unattended
Do not use the product with a damaged cord or plug, after it has been dropped or with any sign of damage
Do not immerse the product or the cord in liquid and do not expose them to moisture
Switch the appliance off and unplug it when not in use and before cleaning, holding the plug rather than the cord
Do not switch the product on without water in the boiling chamber - dry running destroys the heating element
Do not open the lid or remove the condenser unit during operation and until the appliance has cooled: boiling water and steam under pressure are inside
Install the product on a heat-resistant horizontal surface, 20 cm away from walls, furniture and combustible materials
Do not carry the product with hot water inside; drain the residue only after full cooling
Provide free drainage of the distillate into a receiving vessel of adequate volume

Switch the appliance off, unplug it and let it cool completely before cleaning
Remove scale from the boiling chamber after every 8-10 hours of operation: fill with a citric acid solution as directed by the agent's instructions, let it stand, drain and rinse the chamber twice with clean water. Scale reduces output and overheats the heating element
Wipe outer surfaces with a soft damp cloth; do not immerse the product in water and do not use abrasives
Inspect the power cord and plug regularly; operation is prohibited until a damaged cord is replaced at an authorised service centre

Store in a dry, clean, ventilated room at +5 °C to +40 °C and relative humidity of 60 % without condensation, protected from direct sunlight, moisture, dust and heat sources
Keep the air in the storage room free of impurities that cause corrosion of metals
During transport the packed product is secured against movement, and the packaging is protected from precipitation and impact

Warranty: remedy of defects and replacement of defective parts or of the equipment for three (3) years; availability of spare parts and consumables for five (5) years
Disposal: WEEE marking - not to be disposed of with unsorted household waste; hand the product over to a separate collection point for waste electrical and electronic equipment. Metal parts are recycled as scrap metal, electronic components go to specialised processing

Laboratory Electric Distiller for Experiments

Customer testimonials